MKZ AWD V6-3.5L (2008)
-
For assembly, align the armrest bracket locator tab to the backrest frame.
7. Release the 4 pin-type retainers, separate the armrest trim cover panel from the backrest and remove the armrest assembly.
-
For a broken retainer, push the remaining end through and into the backrest frame and install a new pin-type retainer during assembly.
8. Remove the pin-type retainer from the backrest trim cover armrest pocket.
9. To disassemble the armrest assembly, remove the cup holder rubber insert, 2 armrest pivot bolts and armrest bracket.
-
To install, tighten to 10 Nm (89 lb-in).
All seats
10. Release the 4 lower trim cover J-clips at both sides of the backrest and remove the staples.
11. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the backrest foam pad.
Invert the backrest trim cover separating the hook-and-loop strips and remove all rows of hog rings working up the backrest.
12. Remove the backrest trim cover and foam pad from the backrest frame.
13. Remove the 4 backrest-to-pivot bolts.
-
To install, tighten to 10 Nm (89 lb-in).
14. Remove the 4 striker-to-backrest frame nuts, backrest latch striker and support plate.
-
To install, tighten to 6 Nm (53 lb-in).
15. To assemble, reverse the disassembly procedure.
40 Percent
SEAT BACKREST - REAR, 40 PERCENT