MKZ AWD V6-3.5L (2008)
10. Remove the LH recliner outboard cover in the following sequence.
1
Pull out on the LH recliner outboard cover at the front and rear to release the cover retainers and at the bottom, pull the cover away from the
recliner.
2
Slide the LH recliner outboard cover back to separate from the recliner.
-
If not equipped with heated seats, remove the LH recliner outboard cover.
11. If equipped with heated seats, route out the heated seat wire harness and remove the LH recliner outboard cover.
12. Release the cushion trim cover retainer from around the safety belt buckle and separate the hook-and-loop strip.
13. Release the first cushion trim cover J-clip from the rear of the cushion frame.
14. Disconnect and detach the electrical connectors.
-
Slide and disengage the side air bag module electrical connector locking clip, release the tab and disconnect the side air bag module electrical
connector. Detach any pin-type retainers.
