MKZ AWD V6-3.5L (2008)
1. Remove the wheel and tire.
2. Remove the brake caliper flow bolt and position the hose aside.
^
Discard the 2 copper washers.
^
To install, tighten to 25 Nm (18 lb-ft).
3. Remove the 2 brake caliper guide pin bolts.
^
To install, tighten to 27 Nm (20 lb-ft).
4. Remove the brake caliper.
^
If a leaking or damaged caliper piston boot is found, install a new brake caliper.
5. CAUTION: The caliper guide pin boots must be seated correctly on the anchor plate or the guide pins may become contaminated.
Inspect the guide pin boots and make sure they are seated on the anchor plate correctly. The boot has a lip that fits under the edge of the anchor
plate extension.
6. NOTE: During installation, make sure that the brake caliper hose does not become twisted.
To install, reverse the removal procedure.
^
Bleed the brake caliper.
