MKZ AWD V6-3.5L (2008)
Parking Brake Control: Service and Repair
Parking Brake Control
Parking Brake Control
Removal and Installation
1. Remove the floor console.
2. Make sure the parking brake control is in the released position.
3. Disconnect the warning indicator switch electrical connector.
4. Loosen the parking brake control adjusting nut.
5. Remove the 2 parking brake control nuts.
^
To install, tighten to 20 Nm (15 lb-ft).
6. Remove the parking brake control bolt and the parking brake control.
^
To install, tighten to 20 Nm (15 lb-ft).
7. To install, reverse the removal procedure.
^
Adjust the parking brake cable.
