MKZ AWD V6-3.5L (2008)
-
Discard the gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
8. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
3.5L vehicles
9. NOTE: Be sure not to strike the A/C lines against any hard object such as the exhaust manifold when removing the compressor manifold and tube
assembly.
Remove the compressor manifold and tube assembly.
1
Rotate the compressor manifold and tube counterclockwise enough to allow it to be lifted between the exhaust manifold shield and alternator.
2
Remove the compressor manifold and tube assembly.
3.0L vehicles
10. NOTE: Be sure not to strike the A/C lines against any hard object such as the exhaust manifold when removing the compressor manifold and tube
assembly.
Remove the compressor manifold and tube assembly.
All vehicles
11. To install, reverse the removal procedure.
-
Install new gasket seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
12. Evacuate, leak test and charge the refrigerant system.
