MKZ AWD V6-3.5L (2008)
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
Seat cushion removed for clarity.
All seats
1. Remove the affected seat and depower the SRS.
2. Disconnect the electrical connector.
-
Release the retainer on the side of the seat cushion cover to remove the wire for the safety belt buckle switch.
3. Remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Remove the safety belt buckle through the opening in the seat cushion cover.
5. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
To install, reverse the removal procedure.
-
Make sure that the safety belt buckle is routed through the seat cushion cover.
6. Install the affected seat and repower the SRS. If the passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
7. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. See: Air Bag Systems/Testing and
Inspection/Component Tests and General Diagnostics/Occupant Classification Sensor (OCS) System Zero Seat Weight Test
All seats
8. Check the active restraint system for correct operation.
