MKZ AWD V6-3.5L (2008)
Alternator: Service and Repair
GENERATOR
Removal and Installation
1. Remove the A/C compressor.
2. Disconnect the battery.
3. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Disconnect the generator electrical connector.
-
Detach the pin-type retainer and wiring harness.
5. Remove the oil filter.
-
Lubricate the oil filter seal with clean engine oil before installation.
6. Position the engine wiring harness aside.
7. Remove the generator stud nut.
-
To install, tighten to 47 Nm (35 lb-ft).
8. Remove the generator bolt and the generator.
9. To install, reverse the removal procedure.