MKZ AWD V6-3.5L (2008)
Installation
All vehicles
1. Clean the rear transaxle support insulator bolts using a wire brush and apply new Threadlock(R) to the threads.
2. NOTE: 3.0L engine shown, 3.5L engine similar.
Position the transaxle support insulator in place and install the 2 upper bolts.
^
Tighten to 62 Nm (46 lb-ft).
3.5L engine
3. Install the transaxle support insulator through bolt.
^
Tighten to 130 Nm (96 lb-ft).
4. Remove the floor jack and the special tool.
