MKZ AWD V6-3.5L (2008)
6. CAUTION: Do not reuse the bolts for the rear U-joint flange. Install new bolts.
Remove and discard the 4 rear driveshaft-to-pinion flange bolts.
^
Install new bolts and tighten to 70 Nm (52 lb-ft).
7. With the help of an assistant, remove the 4 center bearing support nuts and the driveshaft.
^
To install, tighten to 55 Nm (41 lb-ft).
8. NOTE: If a driveshaft is installed and driveshaft vibration is encountered after installation, index the driveshaft.
To install, reverse the removal procedure.
