MKZ AWD V6-3.5L VIN T (2007)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet pipe.
3. Disconnect the camshaft position (CMP) sensor electrical connector.
4. Remove the bolt and the CMP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
5. NOTE: Lubricate the CMP O-ring seal with clean engine oil.
To install, reverse the removal procedure.
