Navigator 2WD V8-5.4L (2007)
-
Detach the 3 pin-type retainers.
3. Detach the wiring harness pin-type retainer and disconnect the affected power seat motor electrical connector.
4. NOTE: Note position of bushing shoulder for installation.
Remove the bracket-to-pivot bolt and bushing from the power-fold seat motor.
-
To install, tighten to 30 Nm (22 lb-ft).
5. Remove the bracket-to-latch bolt and power-fold seat motor.
-
Slide the power-fold seat motor and bracket away from the latch and torque shaft.
-
For installation, slightly rotate the torque shaft until seated into the power-fold seat motor.
-
To install, tighten to 30 Nm (22 lb-ft).
6. To install, reverse the removal procedure.
