Navigator 2WD V8-5.4L (2007)
16. Disconnect the backrest wiring harness electrical connector.
17. NOTE: Note wiring harness routing for installation.
Route the backrest wiring harness from the cushion.
All seats
18. Release the cushion trim cover rear hook and loop strip from the inboard side.
19. Remove the 4 backrest frame-to-seat track bolts and backrest.
-
To install, tighten to 45 Nm (33 lb-ft).
20. WARNING:
-
Check the side air bag module deployment chute for damage. The side air bag module deployment chute must not be repaired. If there
is any damage to the deployment chute, a new seat back trim cover and deployment chute must be installed as a unit. Failure to do so
may result in personal injury, in the event of an air bag deployment.
-
Inspect the mounting surfaces of the side air bag module for any foreign objects before installing the side air bag module. If any
foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
-
If the side air bag module cover has separated or the air bag material has been exposed, install a new side air bag module. Do not
attempt to repair the air bag module. Failure to do so may result in personal injury, in the event of an air bag deployment.
To install, reverse the removal procedure.
21. Install the seat and repower the SRS.
Seat Backrest - Front, 60 Percent
SEAT BACKREST - FRONT, 60 PERCENT
