Navigator 2WD V8-5.4L (2007)
Part 3
Disassembly and Assembly
All seats
1. Remove the third row 40 percent seat.
2. Remove the third row 40 percent seat backrest.
3. Remove the bolt and the safety belt buckle.
-
During assembly make sure anti-rotation tab is engaged into seat locator.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Release the backrest trim cover outboard J-clip.
5. Remove all the staples.
6. NOTE:
-
Note the spring clip position for installation.
-
Use care when releasing the spring clips. They can fall inside the backrest frame.
Remove the head restraint.
-
Pull the trim cover material away from the head restraint guide to access the spring clips.
-
Release the 2 spring clips by pushing on the side shown.
-
Raise and remove the head restraint.
Manual seat
7. NOTE: Note cable routing for installation.
