Navigator 2WD V8-5.4L (2007)
6. Remove all the staples.
7. Release the hook-and-loop strip.
Manual seat
8. NOTE: Note cable routing for installation.
Remove the 2 screws and the manual latch handle and cable assembly.
-
Route out the cable.
All seats
9. Remove the safety belt guide cover.
10. NOTE: The head restraint sleeve pins are not interchangeable. Note location for installation.
Reach up into the backrest and squeeze the head restraint guide ends together to release and pull the 2 head restraint guides out.
11. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the backrest foam pad.
Separate the hook-and-loop strips and invert the backrest trim cover to the row of hog rings.
12. Remove the row of hog rings.
13. Remove the trim cover.
-
Route the safety belt webbing through the trim cover.
14. Remove the backrest foam pad.
15. Remove the nut, screw and support bracket.
16. Remove the outboard latch-to-cushion frame bolt and outboard latch.
-
To install, tighten to 35 Nm (26 lb-ft).
17. Remove the 2 inboard latch-to-backrest frame bolts and the inboard latch.
-
To install, tighten to 55 Nm (41 lb-ft).
18. Remove the 4 screws and the safety belt retractor cover.
19. Remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
20. Pinch to release the safety belt guide and remove the safety belt retractor.
-
Route through the backrest frame.
