Navigator 2WD V8-5.4L (2007)
Seat Cushion - 40 Percent Seat (Part 2)
Exploded View
Removal and Installation
1. Remove the 20 percent seat.
2. Release the 2 backrest trim cover lower J-clips.
3. Remove the screw and pivot bolt cover.
-
Route out the attaching strap.
4. Remove the 2 pin-type retainers and lower panel.
5. Release the cushion trim cover rear J-clip.
-
Position the backrest downward to aid in trim cover removal.
-
Route the cushion trim cover rear flap and J-clip from between the cushion and backrest.
6. Release the hook-and-loop strip and remaining cushion J-clips.
7. Remove the cushion foam pad and trim cover.
8. CAUTION: Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the seat cushion foam.
Release the hook-and-loop strips and invert the cushion trim cover to the row of hog rings.
9. Remove the hog rings and cushion trim cover.
10. To install, reverse the removal procedure.
Seat Cushion Cover - Second Row, 40 Percent
SEAT CUSHION COVER - SECOND ROW, 40 PERCENT
