Navigator 2WD V8-5.4L (2007)
Seat Cushion - 40 Percent Seat (Part 2)
Exploded View
Removal and Installation
1. Place the seat in the E-Z entry position.
2. Release the trim cover J-clips from both sides of the cushion.
3. Release the outer and inner rear J-clips from the cushion.
4. Latch the seat to the floor and raise the backrest.
5. Release the front J-clip from the cushion.
6. Release the 2 cushion trim cover retainers from the 2 child safety seat LATCH anchors.
-
Pull the cushion trim cover rearward and release the 2 clips.
7. CAUTION: Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the seat cushion foam.
Separate the hook-and-loop strips and invert the cushion trim cover to the row of hog rings.
8. Remove the row of hog rings.
9. Remove the cushion trim cover.
-
Route the trim cover from between the cushion and backrest.
10. To install, reverse the removal procedure.
Seat Backrest Cover - Third Row
SEAT BACKREST COVER - THIRD ROW
