Navigator 2WD V8-5.4L (2007)
Disconnect the battery negative cable. For additional information, refer to Battery.
2. If equipped, disconnect the accelerator pedal-to-brake pedal cable from the adjustable brake pedal motor.
All vehicles
3. CAUTION: Always remove the stoplamp switch with the brake pedal secured to the brake booster push rod and with the brake pedal in
the at-rest position. Do not press or pull on the brake pedal when removing the switch or damage to the switch can occur.
CAUTION: The stoplamp switch must be removed prior to removing the brake pedal and bracket, brake booster and associated
mounting fasteners or damage to the switch can occur.
Disconnect the electrical connector and turn the stoplamp switch clockwise to detach it from the brake pedal bracket.
4. NOTE: An 11 mm, 12-point socket or wrench can be used to compress the 2 tabs on the brake pedal arm pin.
Remove the brake pedal arm pin and disconnect the brake booster push rod from the brake pedal arm.
5. Remove the bulkhead sound insulator.
6. Remove the 4 brake pedal bracket nuts.
^
To install, tighten to 27 Nm (20 ft. lbs.)
7. Remove the 2 brake pedal bracket bolts and remove the brake pedal and bracket.
^
To install, tighten to 27 Nm (20 ft. lbs.)
8. To install, reverse the removal procedure.
