Navigator 2WD V8-5.4L (2007)
Removal
1. Relieve the tension on the parking brake cable system.
2. Remove the brake disc.
3. Remove the front parking brake shoe retaining clip and pin.
4. Remove the parking brake shoe adjuster.
^
Using a suitable tool, spread the bottom of the parking brake shoes apart.
^
Remove the parking brake shoe adjuster.
5. Remove the parking brake shoe adjuster spring.
6. Slide the front parking brake shoe up and out of the guide flange.
7. Remove the front parking brake shoe.
^
Rotate the front parking brake shoe outward.
^
Remove the parking brake shoe return spring.
8. Remove the rear parking brake shoe.
^
Remove the retaining clip and pin.
^
Remove the rear parking brake shoe.
9. Inspect the components for excessive wear or damage and install new parts as required.
Installation
1. CAUTION: Apply the grease only where indicated, do not apply the grease to the parking brake shoes. The grease will contaminate the
brake shoe linings and damage to the linings will result.
Apply a light coat of grease to the 6 parking brake shoe contact points on the disc brake shield.
2. Install the rear parking brake shoe.
^
Hold the rear parking brake shoe in position.
^
Install the retaining pin and clip.
3. Install the front parking brake shoe.
^
Install the parking brake shoe return spring to the rear parking brake shoe and to the front parking brake shoe.
^
Rotate the front parking brake shoe into the guide flange.
4. Slide the front parking brake shoe down into position on the flange.
5. Install the front parking brake shoe retaining pin and clip.
6. Install the parking brake shoe adjuster spring.
7. Install the parking brake shoe adjuster.
^
Using a suitable tool, spread the bottom of the parking brake shoes apart.
^
Install the parking brake shoe adjuster.
8. Using the special tool, measure the inside diameter of the drum portion of the rear brake disc.
