Navigator 2WD V8-5.4L (2007)
7. Connect the transmission fluid cooler tubes and install the secondary latches.
8. Position the air deflector and install the pushpin.
9. Position the hood latch assembly and install the 2 hood latch assembly bolts.
^
Tighten to 25 Nm (18 ft. lbs.)
10. Connect the hood latch cable position retainers.
11. Install the cooling fan shroud.
12. Install the front fascia.
13. Install the RH and LH headlamp assemblies.
14. Connect the battery ground cable. For additional information, refer to Battery.
15. Fill and bleed the engine cooling system.
16. Fill the transmission with fluid and verify correct operation.
17. Evacuate, leak test and charge the refrigerant system. For additional information, refer to Heating and Air Conditioning.
