Navigator 2WD V8-5.4L (2007)
2. Disconnect the cooling fan electronic clutch electrical connector.
3. Remove the nut and the cooling fan electronic clutch harness support bracket from the stud bolt.
^
To install, tighten to 13 Nm (10 ft. lbs.)
4. Release the cooling fan shroud position tab and rotate the shroud upwards until the lower tab locks into position.
5. Using the special tools, remove the cooling fan and clutch assembly.
^
To install, tighten to 55 Nm (41 ft. lbs.)
^
If servicing the cooling fan or cooling fan clutch, refer to Cooling Fan and Cooling Fan Clutch.
6. To install, reverse the removal procedure.
