Navigator 2WD V8-5.4L (2007)
9. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Install the RH CMP sensor and the bolt.
^
Tighten to 10 Nm (89 inch lbs.)
10. Connect the RH CMP sensor electrical connector.
11. Connect the wiring harness retainer from the cylinder head.
12. Connect the A/C compressor electrical connector.
13. Connect the CKP sensor electrical connector.
14. Install the LH radio ignition interference capacitor and the nut.
^
Tighten to 25 Nm (18 ft. lbs.)
15. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Install the LH CMP sensor and the bolt.
^
Tighten to 10 Nm (89 inch lbs.)
16. Connect the LH CMP sensor electrical connector.
17. Install the RH radio ignition interference capacitor and the nut.
^
Tighten to 25 Nm (18 ft. lbs.)
18. NOTE: LH shown, RH similar.
Connect the radio ignition interference capacitor electrical connectors.
19. Connect the wiring harness position retainer to the power steering pump stud bolt.
20. Connect the wiring harness position retainer and the EOP switch electrical connector.
