Navigator 2WD V8-5.4L (2007)
Hose/Line HVAC: Service and Repair
Compressor to Condenser Discharge Line
COMPRESSOR TO CONDENSER DISCHARGE LINE
Removal and Installation
NOTE: Installation of a new receiver/drier cartridge is not required when repairing the air conditioning system except when there is physical evidence
of contamination from a failed A/C compressor or damage to the receiver/drier cartridge.
1. Recover the refrigerant.
2. Remove the compressor discharge fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
3. Remove the condenser inlet jumper line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
4. Remove the compressor-to-condenser discharge line.
5. If removing the condenser inlet jumper line, remove the RH headlamp assembly.
6. If removing the condenser inlet jumper line, disconnect the A/C pressure transducer electrical connector.
