Navigator 2WD V8-5.4L (2007)
15. CAUTION: Make sure each of the 3 driver air bag module wire clips are disengaged from each of the 3 steering wheel hooks before
removing the driver air bag module from the steering wheel.Failure to do so will damage the driver air bag module and steering wheel.
NOTE:
-
Steering wheel is removed for clarity.The rear of the steering wheel is shown.
-
Use a mirror to look at the rear of the steering wheel to locate where the 3 driver air bag module wire clips attach to the steering wheel hooks.
-
Note the position of the 2 driver air bag module locator pins to the steering wheel for installation.
Using a screwdriver or a suitable tool, release each of the 3 driver air bag module wire clips from the steering wheel hooks.
-
Access the 3 driver air bag module wire clips through the back of the steering wheel cover and push the wire clips toward the center of the
steering wheel to release.
16. Disconnect the 2 driver air bag module electrical connectors, then disconnect the horn switch electrical connector and remove the driver air bag
module.
17. Turn the steering wheel so the top of the wheel is back in the straight ahead position (the 12 o'clock position).
18. Open and lower the glove compartment door.
-
If equipped, disconnect the glove compartment door dampener.