Navigator 2WD V8-5.4L (2007)
31. NOTE: There are 2 similar connectors under the driver seat.The driver seat side air bag module electrical connector is located toward the seat
outboard position.
Remove the driver front seat cushion panel shield and disconnect the driver seat side air bag module electrical connector.
32. Install the RCM fuse 32 (10A) to the SPDJB.
33. Connect the battery ground cable.
Reactivation
All vehicles
1. Remove the RCM fuse 32 (10A) from the SPDJB.
2. Disconnect the battery ground cable and wait at least one minute.
3. Connect the driver seat side air bag module electrical connector and install the driver front seat cushion panel shield.
4. Connect the driver side safety canopy module electrical connector.
