Navigator 2WD V8-5.4L (2007)
2. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
3. Loosen the RH rear disc brake caliper bleeder screw until a stream of brake fluid comes out. Have an assistant maintain pressure on the brake
pedal while tightening the RH rear disc brake caliper bleeder screw.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
4. Tighten the RH rear disc brake caliper bleeder screw.
^
Tighten to 16 Nm (12 ft. lbs.)
5. Repeat Steps 1 through 4 for the LH rear disc brake caliper bleeder screw, RH front disc brake caliper bleeder screw and the LH front disc brake
caliper bleeder screw.
^
Tighten to 16 Nm (12 ft. lbs.)
6. NOTE: Go to the Help menu in the scan tool.
Connect the scan tool to the vehicle data link connector (DLC) under the dash and follow the scan tool instructions.
7. Repeat the conventional bleed procedure as outlined in Steps 1 through 5.
8. If the brake pedal feels spongy, repeat the scan tool service bleed procedure.
