Navigator 2WD V8-5.4L (2007)
^
To install, tighten to 12 Nm (9 lb-ft).
4. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can result.
Remove the bolts and position the caliper and anchor plate aside.
^
Support the caliper using mechanic's wire.
^
To install, tighten to 200 Nm (148 lb-ft).
5. Remove the brake disc.
6. Remove the 4 wheel bearing and wheel hub assembly bolts and the wheel bearing and wheel hub.
^
To install, tighten to 150 Nm (111 lb-ft).
7. If installing a new wheel bearing and wheel hub, remove the wheel speed sensor bolt and the wheel speed sensor.
^
To install, tighten to 18 Nm (13 lb-ft).
8. CAUTION: If the original wheel bearing and wheel hub is being installed, install a new wheel bearing and wheel hub assembly O-ring
seal.
To install, reverse the removal procedure.
