Navigator 2WD V8-5.4L (2007)
Body Control Module: Service and Repair
Driver Seat Module (Dsm)
DRIVER SEAT MODULE (DSM)
Removal and Installation
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to a scan tool. This information must be
downloaded into the new DSM after installation.
1. Upload the module configuration information from the DSM into the scan tool.
2. NOTE: The module is accessed with the seat fully in the UP position.
Position the DSM forward to remove it from the bracket.
3. Disconnect the battery.
4. Disconnect the electrical connectors and remove the DSM.
5. NOTE: Once the module is installed it is necessary to download the module configuration information from the scan tool into the new module.
To install, reverse the removal procedure.
