lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTC's P0345/P0349|Page 3002 > < Engine Controls - MIL ON/DTC's P0345/P0349|Page 2996
Page 1
background image

Camshaft Position Sensor: Customer Interest
Engine Controls - MIL ON/DTC's P0345/P0349

TSB 08-16-14

08/18/08

DIAGNOSTIC TROUBLE CODES (DTCS) P0345
AND/OR P0349 - NO DRIVEABILITY SYMPTOMS, MIL
LIGHT ON

FORD:
2007-2008 Expedition

LINCOLN:
2007-2008 Navigator

ISSUE
Some 2007-2008 Expedition and Navigator vehicles may exhibit the malfunction indicator light (MIL) on with DTC P0345 and/or P0349 without any
driveability symptoms.

ACTION
Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

NOTE

IT MAY BE NECESSARY TO REPLACE THE BANK 2 CAM POSITION (CMP) SENSOR CONNECTOR AND RE-ROUTE THE CMP
HARNESS AWAY FROM THE POWER STEERING (PS) HOSE. THE PS HOSE MAY VIBRATE AGAINST THE HARNESS AND CAUSE
INTERFERENCE WITH THE CMP SIGNAL.

1.

Visually inspect the Bank 2 cam sensor wiring for evidence of interference with the PS hose.

a.

If interference, proceed to Step 2.

b.

If no interference, this procedure does not apply. Refer to Powertrain Controls/Emissions Diagnosis (PC/ED) pinpoint test DR.

2.

With vehicle in park, start the engine and turn the steering wheel to the full lock position. Observe the PS pressure hose movement at full lock
position. Repeat the full lock position several times to determine if hose movement under pressure is touching the CMP harness.

a.

If yes, turn off the engine and proceed to Step 3.

b.

If no interference, this procedure does not apply. Refer to PC/ED pinpoint test DR.

3.

Remove air cleaner housing cover.

NOTE

DO NOT TRANSFER THE RIGHT ANGLE ELBOW (ON THE EXISTING CONNECTOR) TO THE NEW CONNECTOR.

4.

Replace the CMP sensor connector C1367 with Pigtail Kit. Refer to included instruction sheet.

5.

Using a tie strap, route the harness away from the PS hose by attaching it to the hole in the valve cover, located on the front left corner.

6.

Install air cleaner housing cover.

7.

Start engine and place in park. Check PS hose to CMP wire harness inter[ace.

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage 
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

OPERATION

DESCRIPTION

TIME

081614A

2007-2008 Expedition,

0.7 Hr.

Navigator: Replace The
CMP Sensor Connector,
Includes Time To Remove

Engine Controls - MIL ON/DTC's P0345/P0349|Page 3002 > < Engine Controls - MIL ON/DTC's P0345/P0349|Page 2996