Navigator 2WD V8-5.4L (2007)
4. Connect the RCM electrical connector.
-
Pivot the connector position assurance lever toward the RCM, drawing the connector in to the RCM.
-
Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
5. Connect the small RCM electrical connector.
Vehicles with bucket seats and no center console
6. Install the 3 RCM push-nut retainers and the RCM cover.
Vehicles with a center console
7. Install the center console.
All vehicles
8. Repower the SRS. Do not prove out the SRS at this time.
9. When installing a new RCM, carry out the steps necessary to complete programmable module installation (PMI).
10. Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition switch from ON to OFF. Wait 10 seconds, then turn the ignition switch back to ON and visually monitor the air bag warning
indicator with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn
OFF. If an air bag SRS fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
-
flash.
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault
