Navigator 2WD V8-5.4L (2007)
18. Position the driver air bag module to the steering wheel, lining up the locator pins.
19. NOTE:
-
Make sure that all 3 driver air bag module wire clips are fully engaged and seated correctly to the steering wheel.
-
Audible clicks will be heard when the 3 driver air bag module wire clips are fully engaged.
Firmly press the driver air bag module to the steering wheel, seating the 3 driver air bag module wire clips to the steering wheel hooks.
-
Check the driver air bag module trim cover to the steering wheel for an even gap clearance and correct movement.
20. Install the steering column lower shroud.
-
If equipped, connect the power tilt steering column switch located on the lower shroud.
21. Install the steering column upper shroud.
22. Install the 3 steering column lower shroud screws.
Vehicles with manual tilt wheel
23. Install the steering column manual tilt lever and screw.
-
Tighten to 6 Nm (53 lb-in).
24. Install the lower steering column opening cover and the 3 screws.
All vehicles
25. Turn the ignition switch from OFF to ON.
26. Install the RCM fuse 32 (10A) to the SPDJB and install the cover.
27. WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the
battery ground cable is connected.
Connect the battery ground cable.
28. Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the
air bag modules installed.The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS
fault is present, the air bag warning indicator will either:
-
fail to light.
-
remain lit continuously.
-
flash.
