Navigator 2WD V8-5.4L (2007)
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS], if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Remove the third row 40 percent seat.
2. Remove the bolt and the safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
3. NOTE:
-
When installing the safety belt buckle, make sure to engage the anti-rotation tab to the sheet metal.
-
Make sure the safety belt buckle is accessible to the passenger after installation.
To install, reverse the removal procedure.
4. Check the active restraint system for correct operation.
Safety Belt Buckle - Third Row, 60 Percent Seat
SAFETY BELT BUCKLE - THIRD ROW, 60 PERCENT SEAT
