Navigator 2WD V8-5.4L (2007)
Installation
1. Install the safety belt buckle and pretensioner.
1
Position the safety belt buckle and pretensioner to the seat.
-
Align the safety belt buckle and pretensioner locator tab to the hole in the seat frame.
-
Check that the safety belt buckle end is accessible after positioning.
2
Install the nut.
-
Tighten to 55 Nm (41 lb-ft).
3
Route the safety belt buckle switch and pretensioner electrical connectors as noted in removal.
2. Connect the electrical connectors. Attach the electrical connectors and route the wire harnesses as noted in removal.
3. Install the 60 percent front seat.
4. Repower the SRS.
5. Check the active restraint system for correct operation.
Safety Belt Buckle and Pretensioner - 40 Percent
SAFETY BELT BUCKLE AND PRETENSIONER - 40 PERCENT
Removal and Installation
WARNING:
-
To reduce the risk of personal injury, do not use any memory saver devices.
-
All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use
during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow
these instructions could increase the risk of injury in collisions.
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
