Navigator 2WD V8-5.4L (2007)
injury in collisions.
1. NOTE: Inspect the D-ring cover for damage. If the cover is damaged or does not remain closed, install a new D-ring cover.
Remove the upper and lower B-pillar trim panels.
2. Release the 2 pin-type retainers and safety belt guide.
3. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
4. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
When installing the safety belt retractor, make sure to engage the anti-rotation tab to the sheet metal
-
Remove the shipping clip after safety belt retractor installation.
To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
