Navigator 2WD V8-5.4L (2007)
6. NOTE: After installing the wheel knuckle bushing, make sure to measure the bushings position in the wheel knuckle bore. The measurement from
the bushings outer metal surface to the machined face surface of knuckle bore should be 2.54 mm (0.16 in) +/- 0.25 mm (0.01 in).
If necessary, use the special tool to adjust the bushing position in the wheel knuckle bushing bore.
7. CAUTION: Do not tighten the upper trailing arm-to-knuckle bolt until the installation procedure is complete and the weight of the
vehicle is resting on the wheel and tire assemblies.
Connect the upper trailing arm to the wheel knuckle.
^
Tighten the bolt to 250 Nm (184 lb-ft).
8. Remove the jack stand from under the lower arm.
