Navigator 2WD V8-5.4L (2007)
Stabilizer Link: Service and Repair
Front
Stabilizer Bar and Link
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of
these parts.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: The hex holding feature can be used to prevent turning of the stud while removing the nut.
Remove and discard the 2 stabilizer bar link upper nuts.
^
To install, tighten to 80 Nm (59 lb-ft).
