Navigator 2WD V8-5.4L (2007)
Wheel Bearing: Service and Repair
Rear
Wheel Bearing and Wheel Hub
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of
these parts.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: Have an assistant press the brake pedal to keep the axle from rotating.
Remove and discard the halfshaft nut.
^
To install, tighten to 300 Nm (221 lb-ft).
3. Using a suitable hub puller, separate the outboard CV joint from the wheel hub.
