Navigator 2WD V8-5.4L (2007)
10. CAUTION: Only use hand tools when removing the engine mount nuts or damage to the engine mount may occur.
For four wheel drive (4WD), remove the LH engine mount nuts and lift the engine to gain clearance for the trans cooler tubes.
11. Remove the transmission fluid cooler tubes from the vehicle.
Installation
1. Position the transmission fluid cooler tubes in the vehicle.
2. Install the bolt and transmission fluid cooler tube bracket to the side of the transmission.
^
Tighten to 48 Nm (35 lb-ft).
3. Install the nut and transmission fluid cooler tube bracket to the front of the engine.
^
Tighten to 40 Nm (30 lb-ft).
4. Connect the transmission fluid cooler tubes to the transmission fluid cooler hoses.
