Navigator 2WD V8-5.4L (2007)
Installation
1. Position a new manual control lever seal in place.
2. Using the special tool, install a new manual control lever shaft seal.
3. Install the manual lever in the case.
1
Slide the manual lever in the case.
2
Position the spacer in place while sliding the manual lever into the spacer.
3
Position the manual valve inner lever while sliding the manual lever and lining up the roll pin hole.
4
Install the roll pin.
4. Position the park rod in place. Push down on the park pawl and position the park rod in place.
5. While holding the park rod down, install the park rod actuating plate.
^
Tighten to 10 Nm (89 lb-in).
