Navigator 2WD V8-5.4L (2007)
8. CAUTION: Do not touch the electrical connector pins or the exposed solenoid tabs on the TCM. Electrostatic discharge may occur and
may cause damage to the mechatronic unit.
With the release tab down, pull the outer shell of the bulkhead electrical connector out of the TCM.
9. CAUTION: Do not touch the electrical connector pins or the exposed solenoid tabs on the TCM. Electrostatic discharge may occur and
may cause damage to the mechatronic unit.
Pull the bulkhead electrical connector out of the transmission.
10. Remove the 11 bolts from the mechatronic assembly and remove the mechatronic assembly.
Installation
1. NOTE: Before installing the mechatronic assembly into the transmission case, verify presence and correct orientation of the thermal bypass valve,
pump adapter seal and center support seals. Also note that one or more of the center support seals may have remained in the mechatronic assembly