Navigator 2WD V8-5.4L (2007)
6. NOTE: Do not rotate the driveshaft when removing the slip yoke from the transmission output shaft.
Index-mark the driveshaft slip yoke and the transmission extension housing.
^
Mark the transmission output shaft to the transmission extension housing after removing the driveshaft.
7. CAUTION: Coat the threads of the original bolts with sealer.
CAUTION: The driveshaft flange fits tightly on the rear axle pinion flange pilot. To make sure that the driveshaft flange seats squarely
on the pinion flange, tighten the bolts evenly in a cross pattern as shown.
CAUTION: Make sure all index marks are aligned.
To install, reverse the removal procedure.
^
Tighten the driveshaft flange bolts to 103 Nm (76 lb-ft).
