Navigator 2WD V8-5.4L (2007)
4. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can result.
Remove the bolts and position the caliper and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 190 Nm (140 lb-ft).
5. Remove the brake disc.
6. Detach the wheel speed sensor harness from the retainers and disconnect the wheel speed sensor electrical connector. Push the wheel speed sensor
harness grommet through the brake disc shield.
7. Remove the 4 wheel bearing and wheel hub bolts, the wheel bearing assembly and the wheel speed sensor as an assembly.
^
Route the sensor wiring through the access hole in the brake disc shield.
^
Discard the bolts.
^
To install, tighten to 185 Nm (136 lb-ft).
8. If necessary, remove the wheel speed sensor bolt and the wheel speed sensor from the wheel bearing and wheel hub.
^
To install, tighten to 18 Nm (13 lb-ft).
9. To install, reverse the removal procedure.
