Navigator 2WD V8-5.4L DOHC VIN R (2001)
5. Remove the power door lock actuator rivet.
6. Disconnect the power door lock actuator electrical connector.
^
Release the wiring harness locator.
7. Disconnect the actuating rods.
1
Disconnect the lock cylinder actuating rod.
2
Open the locking clip.
3
Disconnect the exterior door handle actuating rod.
8. Remove the door latch bolts
^
Discard the bolts.
9. Disconnect the door ajar switch electrical connector.
10. Remove the front door latch.
INSTALLATION
1. To install, reverse the removal procedure.
^
Transfer parts as necessary.
^
If necessary, use Multi-Purpose Grease F5AZ-19G209-AA (aerosol) or equivalent meeting Ford specification ESR-M1C159-A to lubricate the
latches.
^
Use the special tool to install the new rivets.