Navigator 2WD V8-5.4L DOHC VIN R (2001)
3. Have an assistant pump the brake pedal until clear fluid flows from both brake tubes without air bubbles.
4. Remove the short brake tubes and install the brake outlet tubes.
5. Bleed each brake tube at the brake master cylinder as follows:
1
Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
2
Loosen the rear-most brake tube fittings until a stream of brake fluid comes out. Have an assistant maintain pressure on the brake pedal while
tightening the brake tube fitting.
3
Repeat this operation until clear, bubble-free fluid comes out.
4
Refill the brake master cylinder reservoir as necessary. Repeat the bleeding operation at the front brake tube.
6. While the assistant maintains pressure on the brake pedal, tighten the brake tubes.
