Navigator 2WD V8-5.4L DOHC VIN R (2001)
Air Door Actuator / Motor: Service and Repair
Blend Door Motor
Main Climate Control
REMOVAL
1. Remove the rear floor duct.
2. Remove the floor duct.
3. Remove the electronic actuator.
1
Disconnect the connector.
2
Remove the screws.
3
Pull down to release the actuator shaft and remove the electronic actuator.
INSTALLATION
1. To install, reverse the removal procedure.
Auxiliary Climate Control
Auxiliary Blend Door and Auxiliary Mode Door Actuator
REMOVAL
NOTE: The auxiliary blend door actuator is shown; the auxiliary mode door actuator is similar.
1. Remove the LH quarter trim panel.
2. Remove the electronic actuator.
1
Disconnect the connector.
2
Remove the screws.
3
Remove the electronic actuator.
INSTALLATION
1. To install, reverse the removal procedure.