Navigator 2WD V8-5.4L DOHC VIN R (2001)
10. Install the line brackets.
1
Position the bracket.
2
Install the nut.
^
Snap the line securely into the bracket.
CAUTION: Overtightening of the nut will cause the stud to break away from the floorpan.
NOTE: The bracket must be positioned equally between the white location marks on the line.
11. Install the muffler heat shield.
1
Position the shield.
2
Install the nuts.
12. Lower the vehicle.
13. Turn on the air suspension switch, if equipped.
14. Install the grommet seal and retainer.
NOTE: Verify that the lines are entering through the center of the floor opening and that the retainer locating marks are positioned correctly.
15. Connect the heater outlet hose coupling.
^
Lubricate the coolant hoses with MERPOL(R) meeting Ford specification ESE-M99B144-B or plain water only, if needed.
16. Install the quarter trim access panel.
17. Install the spare tire.
18. Fill the cooling system.
Front Auxiliary Heater Outlet and Inlet Line
REMOVAL
