Navigator 2WD V8-5.4L DOHC VIN R (2001)
Hose/Line HVAC: Service and Repair
Auxiliary Climate Control
Front Auxiliary Evaporator Outlet and Inlet Line
REMOVAL
NOTE: The 5/8 inch front auxiliary evaporator outlet line is shown, the 3/8 inch front auxiliary evaporator inlet line is similar.
1. Recover the refrigerant from the system. Refer to: Heating and Air Conditioning, Service and Repair, Refrigerant Discharging and
Recovery Procedure, See: Service and Repair/Refrigerant Discharging and Recovery procedure
2. Turn the air suspension switch off, if equipped.
3. Raise and support the vehicle.
4. Remove the wheel and tire assembly.
5. Remove the RH front fender splash shield.
1
Remove the bolts.
2
Remove the pin-type retainers.
3
Remove the front fender splash shield.
6. Remove the three line bracket retaining nuts.
7. Remove the three line brackets by inserting a screwdriver in the stud hole and twisting.
CAUTION: Pull the bracket off the stud before attempting to pry it off the lines to prevent component damage.
