Navigator 2WD V8-5.4L DOHC VIN R (2001)
1. Install the inlet line (19835-E).
^
Install the end with the hose over the rear axle between the frame and the body.
2. Connect the inlet line (19835-E) peanut fitting.
1
Connect the inlet lines.
2
Loosely install the nut.
3
Snap the peanut fitting into the torque retention bracket.
3. Install the inlet line (19835-F).
^
Starting from the rear of the vehicle, insert the end with the orange tape between the frame and the body.
4. Connect the inlet line (19835-F) to the inlet line(19835-E).
1
Connect the inlet lines.
2
Loosely install the nut.
