Navigator 2WD V8-5.4L DOHC VIN R (2001)
Leak Detection Valve: Service and Repair
REMOVAL
1. Remove the evaporative emission canister.
2. If required, remove the retainer.
^
Slide the retainer off the bracket.
3. Remove the evaporative emission canister vent solenoid.
NOTE:
^
Inspect and replace the O-ring seal as necessary.
^
A twisting and pulling motion is required to remove the canister vent solenoid.
INSTALLATION
1. To install, reverse the removal procedure.
^
Carry out the evaporative emission system leak test. See: Testing and Inspection/Component Tests and General Diagnostics/Component
Tests/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Component Tests/Evaporative Emission Repair Verification Drive Cycle
NOTE: Lubricate O-ring seals with MERPOL(R) O-ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.
