Navigator 2WD V8-5.4L DOHC VIN R (2001)
Engine Temperature Sensor: Service and Repair
Cylinder Head Temperature (CHT) Sensor - 5.4L (4V)
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the RH dual converter y-pipe. Refer to See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair
3. Remove the air conditioning water deflector retainer and position the delector aside.
4. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
NOTE: The CHT sensor is located at the back of the right side cylinder head.
5. Remove the CHT sensor.
6. To install, reverse the removal procedure.
