Navigator 2WD V8-5.4L DOHC VIN R (2001)
Install the front suspension upper arm.
1
Position the front suspension upper arm.
2
Install the bolts and nuts.
2. Install the upper ball joint castle nut.
1
Install the nut.
2
Install a new cotter pin.
3. WARNING: When a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surfaces of the
wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without proper metal-to-metal
contact at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while the vehicle is in motion, causing
loss of control.
Clean the wheel hub mounting surface.
4. NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
Install the tire and wheel assembly.
5. Inspect and adjust the front end alignment.
